Hi-Lux Academy

Adjusting the eyepiece diopter, rear mount, eye relief to setting parallax for the Malcolm 8X USMC
  • 1 min read
Have you ever taken something apart and forgotten how to put it back together?
TL;DR Tighten the top screw of the Malcolm Vintage Sniper Competition Mounts to 6-7 in lbs.
  • 1 min read

It is critical to properly set the locking nut within the crescent groove of the standard bases. Although, the Malcolm 8X scope mounts have been calibrated at the factory to properly fasten to the provided crescent cut bases, you may need to adjust the friction screws in the mount. In this video, we’ll be going over how and when you should adjust the friction screws within the Malcolm 8X USMC mounts.

  • 2 min read
The Malcolm 8X USMC scope comes with Lyman style micrometer rear mount and front ring. In this video, we’ll be going over what you need to periodically check to ensure that the mounts work properly.
  • 1 min read
There are certain scenarios when you would need to remove the scope body from the externally adjusting mounts. Such as adjusting the friction screw on the mounts, or removing the return spring.
  • 1 min read

If you expect to frequently adjust elevation on your Malcolm 6X Long Rifle Telescope, you may opt to use the Fine Elevation Adjustment Set. 

The FEASET is a bolt on upgrade to the rear scope mount. It allows you to adjust the elevation on the Malcolm 6X Long Scope without having to manually loosen and raise the scope block.

To install the front ring on to the scope tube, slide the front ring on to the objective end sunshade, with the flat spring facing the back of the scope.

The front ring will slide into the front dovetail by the muzzle. 

In this video, we will be installing the Rear Mount for the Malcolm 6X Long Rifle Telescope on a Uberti 1885 High Wall with a 30” Octagon Barrel.

Search